Air Intake Hose and Fittings
As fitted to MKI minis and variants. Original style rubber material wrapped over a wire coil. As an improvement to the original weak design, these are also bonded to a nylon interior membrane for additional strength. The original length in the parts books are 45 inches for normal minis and 47 inches for the S. These are about 49 inches (give or take 1/2 an inch) so you have a bit more length to play with. Two part numbers may apply to this, either 24a1975 or 24a1256, and this is a direct replacement for both
Also available are the correct wire clamps.
And the large P clip that holds the tube to the inner wing (14A9982). Powder coat finish
The grommet that sits in the bulkhead, 24A2195
Just a comment about posting these tubes overseas, it is expensive due to their length. Current quotes I am receiving are in the region of £20 for Europe and about £40 - £70 to other parts of the world. If this is prohibitive, consider the reducer kit as this packs a lot smaller and is far lighter, costing about £6 to Europe
| Air Intake Tube, rubber over wire 24A1256 | £55.00 | |
| Air Tube clamp (pair) HCS156 or HCS2228 | £3.60 | |
| Inner wing P clip 14A9982 | £4.30 | |
| Rubber bulkhead grommet 24A2195 | £4.00 |